[LiSA-Devel] [GitHub] Install and run LISA using kernel rpm packages

[Andreea-Cristina Hodea]

On Tue, Feb 19, 2013 at 11:04 PM, Radu Rendec <radu.rendec at mindbit.ro> wrote:
> The setup includes 2 additional test VMs called "test1" and "test2".
> They can be any linux flavor you like, since they're only going to be
> used for basic network testing such as ping and tcpdump.
>
> +-------+  vlink1  +------+  vlink2  +-------+
> | test1 +----------+ LiSA +----------+ test2 |
> +-------+          +------+          +-------+
>
> The minimal LiSA configuration for supporting the setup described above
> is this:
>
>         conf t
>         int netdev eth2
>         int netdev eth3
>         exit

> Once you get connectivity between the 2 test machines, you can look at
> the forwarding table using "show mac-address-table dynamic" and check
> that the MAC addresses were learned properly.

Thank you so much Radu for the detailed response. I have managed to
simulate the network above and the MAC addresses were learned properly
for both eth2 and eth3. Though, I got the message "failed to enable
cdp on interface eth2 : No such file or directory" for both
interfaces. Is there something I've missed?

Tomorrow I'm writing the wiki with the steps above.

Andreea